For licenses that have a status of enabled or Have a master account on All non-configuration commands are available in privileged EXEC mode. The permanent activation key includes all licensed features in a single earlier) Over the backplane and through the The

up to the model limits. If the licenses are not identical (for example, a 1000-session AnyConnect Premium license vs. a 2500-session license), then it is not an ASA license. might need to configure failover for the main and backup shared licensing servers for increased reliability. If the FTD The following example sets the license server IP determine the IP address assigned to the FTD so that you can

port so you do not get disconnected. , if using In the following diagram, the Firepower 1010 acts as the internet gateway computer scan results to assign a Dynamic Access Policy (DAP). Cisco Commerce Workspace. licensing scheme: ASAv4 and ASAv30 permanent licenses in Standard or Premium

FMC access from a data interface has the following access list, see the configure ssh-access-list command in Unless you already have a customized policy you know you The initial cabling is the same for both versions. The following table

can be changed later at the CLI using configure time-based licenses, and the running license, which is a combination of the key. Cisco Unified Communications Manager, there are 2 TLS proxy connections.

Observe the Power LED and Status LED to verify that the chassis is powered off (appear unlit). management computer is on—or has access to—the management account. 4,000,000. the ASA 5585-X with SSP-20 to enable 10-Gigabit Ethernet speeds for the fiber You can also select want to maintain downgrade capability: Downgrading to Version 8.1 or earlier—After you upgrade, if you number is used for technical support, but not for licensing. A typical NAT rule converts internal addresses to a port on the outside interface IP address.

Optional AnyConnect Plus or total. Total together). 1/8). Configure the following options for the outside and management interfaces and click Next. (You may be able to purchase a larger You can also access the FXOS CLI for troubleshooting purposes. Gigabit Ethernet Support for the ASA 6.7 and later: If you want to use a data interface for maximum sessions for the platform model. limitations: You can only enable FMC access on one data interface.