Sponsored Post. https://gallantbullets.com/pages/shipping-policy.

Too much crimp can also pinch the coating and scrape it off, so a minimal crimp is recommended. Initial testing has proven the polymer coated bullets to be more accurate with a dramatic decrease in smoke. How should I load polymer coated bullets?

Handloading coated bullets requires special attention to prevent the coating from being scraped off. barrel, (We will never divulge your email to a 3rd party), Visit our FAQ page for more detailed And of course they come in our signature Initial testing has proven the polymer coated bullets to be more accurate with a dramatic Reloading coated bullets is slightly different than loading a jacketed or lead bullet. By David Maccar. If you strip or damage the coating it may caused lead fouling in your barrel, increased smoke, and/or decreased accuracy. bullets can be pushed faster with no leading. Reloading with Bullet Corp coated bullets should be done using quality reloading equipment with data obtained from a reloading manual. Handloaders can use lead-free primers, such as those made by Fiocchi.

Our gift cards have no additional processing fees. Many times if it’s right on the line it will not cut under the lube ring but above the lube ring.

A light taper crimp is the preferred method for crimping, if the body or base of the bullet is squished by too much crimping the result may be poor accuracy and/or keyhole issues or gas cutting. Federal Syntech ammunition is loaded with a polymer-coated lead bullet. More Range Life. I’m now trying out Clays and like it quite a bit. 2,890. This will give you the maximum length of cartridge for that gun. By totally encapsulating the bullet with this non-toxic coating, the lead to bore contact is eliminated along with the smoke and leading associated with traditional cast bullets. Discount Program (5% off for Forum Members).

Eggleston Polycoated Bullets are coated with the highest performing polymer on the market today. These will work in Bullet Feeders unlike lead bullets. Rimfire Power. Federal Syntech ammunition is loaded with a polymer-coated lead bullet. You have to back off a few thousandths from that length to give some leeway for press variations and variations in bullet length.

Sport Pistol's low-muzzle-flash formulation is also optimized for polymer-coated bullets, whereas comparable powders can dissolve polymer coatings at the bullet base during ignition. Some of our bullets are shorter than typical lead or plated bullets, and use a shorter C.O.L as a result. Gun Reviews. . Measure the length of the bullet3. You should see just a very slight impression (almost none) in the coating from the crimp. *Be sure that you have enough flare on the case mouth when seating the bullet or the coating may be scraped off, causing performance issues. The coating prevents leading, reduces or eliminates smoke produced by the waxy lube required on lead bullets, and some designs may require less gunpowder to push them to the same velocity as jacketed bullets. Polymer Performance ... Our coated bullets are available in multiple colors which are great for identifying loads, are custom sized for your specific firearm, and are more affordable than either plated or jacketed bullets. Whether it's for some of our great gear or a box of bullets, there's a gift card value for the perfect gift. Is there a "sticky" already started on painted bullet suppliers & prices here in GT somewhere? Remove your barrel.2. These bullets are now available as components for handloading.

information.

The data has not otherwise been tested or verified by Bullet Corp (pty) Ltd. Bullet Corp (pty) Ltd, its agents, officers and employees accept no responsibility for the results obtained by persons using such data and disclaim all liability for any consequential injuries or damages. The perfect amount of crimp will hold the bullet in place but not affect the coating.