The wheel hub mounting bolt torque specification also provides a secure fit for the wheel hub and provides proper seating of the wheel hub to knuckle attachment. Chevrolet Astro Axle Nut Torque. I am trying to find the correct torque spec. So what should the torque be on the front driver and passenger side bolt that hold the HUB assembly on be? Proper torque secures the axle nut and keeps the proper load on the hub assembly. Safari 4WD 1990-1995 180/244-ft/lbs/Nm. Safari AWD 1996-2005 147/200-ft/lbs/Nm. I have replaced the HUB assembly on both sides twice. Just pull the old hub and bearing assembly off, … Chevrolet Blazer, Yukon Axle Nut Torque.

Front Wheel Hub Torque Specifications Spécifications de couple pour moyeu de roue avant Always refer to the specific vehicle manufacturer’s instruction manual for installation procedures. For front axle nut and hub/bearing assembly mounting bolts for my 2000 dodge dakota 4x4, Monday, August 19th, 2019 AT 7:12 PM Every wheel hub is, in some way, connected to a wheel bearing.

Just to clarify. This video will show you where to find the proper torque specs for a Timken hub assembly.

The 3 bolts that hold the hub/bearing assembly to the steering knuckle are torqued to 123 ft. Lbs. (Merged), 2006 Dodge Dakota 6 Cyl Two Wheel Drive Automatic Toujours se référer au manuel d’instruction du fabriquant pour les procédures d’installation. Improper torque can lead to wheel hub movement and allow potential damage to the wheel hub and surrounding components. 4WD 2002-2013 177/240-ft/lbs/Nm. Transcript: One of the most common mistakes people make when installing a new hub assembly is improperly torquing the axle nut.

This makes installation significantly easier and cheaper. I'm needing to know what the torque should be to be sure I am doing it properly. Need To Remove And Replace Left Front Wheel Bearing Hub Need Removal And Replacement Instructions. Hello, I Was Wondering About This Dakota. thank you for your reply. And the axle nut (hub nut) on the axle end gets torqued to 126 ft. Lbs. Proper torque is critical for two reasons. 4WD 1980-1991 With manual locking hubs: Tighten adjusting nut to 50 ft-lbs/68 Nm while turning hub. Install the hub/bearing into the steering knuckle and tighten the bolts to 120 ft. Lbs. I have had problems with the bearings several times. They are either pressed or bolted together, and they frequently come as one "wheel hub and bearing" assembly. Chevrolet Avalanche Axle Nut Torque. Once tighten does it need to be loosen then finger tight?

What It Does As You Take Off It Will Drive Perfect Then It Skips Second Gear And Goes Into Third... How Do I Identify The Spec For Rear Differential In A Vehicle At A Junk Yard. Thanks again I look forward to hearing back. How Do You Change Out Front Hub Assembly On A Dodge Dakota.